E-Mail: Sales - Tech Support

Skeleton conversion

1. Remove black wire of the oscillator board from CW keying jack
2. Remove and discard black wire of keying jack from bare ground wire
3. Remove red wire of oscillator board from red LED lead
4. Remove green wire of oscillator board and attached 33pf cap
5. Solder the leg of the 15/18pf cap to the bare wire of radio SO239 connector
6. Remove yellow 2200K cap from teflon wire of input transformer
7. Unsolder the 56/120pf cap from teflon wire and also from ground tab
8. Solder the teflon wire to junction of the 200/360 ohm resistor and 180pf cap
9. Solder lead of 56/120pf cap to the teflon wire on small relay from transformer
10. Solder other lead of 56/120pf cap to bare ground wire from antenna connector
11. Unsolder oscillator board from input transformer